FTM can work on only and requires special calibrations so that an off the shelf won’t be able to provide accurate measurements. Set high throughput channel width to maximize performance. To get the latest version for newer kernels, please use the firmware git tree instead. Use the lowest setting for maximum battery life. Mixed mode protection Use to avoid data collisions in a mixed

Uploader: Tutaxe
Date Added: 13 July 2010
File Size: 22.70 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 18835
Price: Free* [*Free Regsitration Required]

This setting pro/wireess only available if the WiFi adapter is one of the following: Enables you to expand the number of coverage areas or confine a coverage area. Auto Tx Preamble allows automatic preamble detection.

Table of Contents Introduction. These scenarios have pro/wrieless tested thoroughly on and up, less so on earlier devices. Default Power settings are based on the computer’s power source. Select Enabled or Disabled to set the No security None can be selected to enable network setup and troubleshooting. Adjust the slider for the desired setting. Power consumption savings vary based on Network Infrastructure settings.

This setting is only available to the user and is not available for export in an administrator waln. Monitor sniffer – see note. Except where otherwise noted, content on this wiki is licensed under the following license: Always use Auto Tx Preamble to provide optimal network throughput. This will put lots of pressure on the memory subsystem, but it will allow you to hear 12K long packets.


Downloads for IntelĀ® Wireless WiFi Link 4965AGN

If not, use Long Tx Preamble. For general questions about Wi-Fi on Linux using Intel’s devices, you can send an email to linuxwifi intel. Power Management Lets you select a balance between power consumption and WiFi adapter performance. This means that the bleeding edge of the backport tree will run against decently recent kernel usually against Linus’s tree.

To return to the default value, click the Use default value checkbox. Having Wi-Fi and Bluetooth running at the same time is a challenge.

Sidebar Users main page. Select the Advanced tab. NAN isn’t considered stable yet and may or may not work depending on the firmware version.

iwlwifi – Debian Wiki

These wireless modes Modulation type determine the discovered 496agn points displayed in the WiFi Networks list. To achieve transfer rates greater than 54 Mbps on The firmware necessary to support the devices is distributed separately under the firmware license. In order to determine if your device is a ‘D’ version, you can 496a5gn the dmesg output: Select when connecting to ad hoc networks that contain stations that do not support ad hoc power management Maximum Power Savings: The steps for installing and configuring this are very distribution specific and the tools differ, but distributions have this enabled.


Creative Commons Attribution 4.

This setting is available only if the WiFi adapter is one of the following: Some common sources of platform noise might be: Changes the preamble length setting received by the access point during an initial connection. Unless the other computers in the ad hoc network use a different channel from the default channel, there is no need to change the channel. An administrator can 496agn or disable support for high throughput mode to reduce power-consumption or conflicts with other bands or compatibility issues.

MIMO increases data throughput to improve transfer rate.